Retrofits into most existing detail and/or wash bays 15ft wide x 10ft tall x 32ft long*. 1 door or 2 door access compatible.
1 door = drive in, back out.
2 door = pull thru.
*Bays less than 32ft may not fully wash all vehicles, minimum length is 28ft 6in. If you are close, but not sure, send us a drawing and we may be able to help you make it fit.
Detail Space
Design allows the same existing space to continue to detail and Vac. Keep pressure washer and Vac where they are and still usable.
The wash is designed to give unobstructed access to the car even when it is parked on the positioning pad, this way you can pull the car in, vacuum, sanitize, detail, and pressure wash if necessary.
Power
Single phase 220/240 VAC 30 amp circuit 4 wire #10
Water Supply
Any existing hose bib with 5 gallon a minute flow rate.
Sewer
Existing drain and oil/water separator.
Permits
"Portable" and may not require permitting.
Installation Time
Installs in about 2 1/2 to 3 days, from unloading truck to washing cars. The typical install starts Tuesday morning and it's up and running by Friday morning, in many cases without completely shutting down the bay for more than a day.
